WESTLOCK CONTROLS CORPORATION
280 N. MIDLAND AVE., STE. 258, SADDLE BROOK, NJ 07663 TEL: 201-794-7650 FAX: 201-794-0913
www.westlockcontrols.com
10/5/2013
TECH-477/D.W.O. 21424
Page 65 of 206
Relative
Index
Parameter Name
Description
Default
Value
Read/
Write
the details of MODE
calculation is a block class
specific (see data sheets).
2. Permitted
Defines the modes which are
allowed for an instance of the
block. The permitted mode is
configured by the block
design group, i.e. is defined
for every block in the
according data sheet. Any
mode change request will be
checked by the device to
insure that the requested
target mode is defined as a
permitted mode.
3. Normal
This is the mode which the
block uses during normal
operation conditions. This
parameter may be read by
an interface device but is not
used by the block algorithm.
The normal mode is not used
in the scope of this profile
and for further use.
Blocks of class A devices
provide in minimum the
MODE "Auto" as mandatory.
MODE calculation is
mandatory for Function
Blocks of class B devices
only.
7
ALARM_SUM
The parameter ALARM_SUM
summarizes the status of up
to 16 block alarms. For each
alarm, the current states,
unacknowledged states,
unreported states and
disabled states are
maintained.
NOTE: This feature is not
fully supported by the actual
profile. For this profile the
current state part of the
alarm is used only.
0,0,0,0 r
9
ACT_STROKE_TIME_DEC
Minimum of time to move
-
r
