WESTLOCK CONTROLS CORPORATION
280 N. MIDLAND AVE., STE. 258, SADDLE BROOK, NJ 07663 TEL: 201-794-7650 FAX: 201-794-0913
www.westlockcontrols.com
10/5/2013
TECH-477/D.W.O. 21424
Page 118 of 206
DEVICE_CERTIFICATION
Device Certification: Certification of the device.
WRITE_LOCKING
Write Locking: Set the write protection by software.
FACTORY_RESET
Factory Reset: A selection of reset procedures, which are executed
by pressing the “Execute” button. These procedures
are:
-No function: Do nothing;
- Factory Reset: Resets the device and sets most of the
device’s parameters to the default factory values;
- Warm start: Resets the device;
- Reset Address to ‘126’: Resets the device and set the node
address to 126.
Identification
Descriptor: Text defined by the user to describe the device
within an application. It is a Physical Block
parameter with space to store 32 characters.
Message: Also has space to store 32 characters and can be
used for any proposal, especially to describer better
the application and the plan where the device is
located.
Installation Date: User can set here the date when the device was
installed. It has space to store 16 characters.
LOCAL_OP_ENA
Local Operation: Enable or disable the local operation via keypad.
IDENT_NUMBER_SELECTOR
PROFIBUS Ident Number: Device Ident number in use. The hexadecimal
number 0E88 is the specific identification number
assigned to ICoT PA.
HW_WRITE_PROTECTION
HW Write Protection: This parameter shows the status of hardware write
protection.
The board has a dipswitch named SW4, where is possible to
set the hardware write protection.
FEATURE
FEATURE (Supported): Indicates which optional features are implemented
in the device.
FEATURE (Enabled): Indicate the status of the implemented optional
features.