WESTLOCK CONTROLS CORPORATION
280 N. MIDLAND AVE., STE. 258, SADDLE BROOK, NJ 07663 TEL: 201-794-7650 FAX: 201-794-0913
www.westlockcontrols.com
10/5/2013
TECH-477/D.W.O. 21424
Page 128 of 206
Time Interval (FST): Measured of last full stroke test time interval.
Time and Date: Current date from RTC (TIME_AND_DATE parameter).
Write in this parameter to adjust the RTC.
The DTM will display the time and date format according
to what is defined on Windows (see time and date format
configurations in Windows Control Panel in order to
change it). Setting a new TIME_AND_DATE value must
follow the same format, otherwise, the DTM will reject it.
Independent to what's defined in Windows settings, the
device will store the values according to its data type
(MM/DD/YY HH:MM:SS), so the year is just a two digits
number.
LCD Contrast: Changes the contrast of the LCD, The range is [26, 63].
This contrast will be use when the electronic temperature
is between -5ºC and 60ºC.
If the electronic temperature is equal or below -5ºC the
contrast will be set automatically to 63.
If the electronic temperature is equal or above 60ºC the
contrast will be set automatically to 26.
WSN Password: Password to enable to change the serial number
WSN Control Flag: This flag will inform if the serial number was changed
properly.
WSN Serial Number: Show the current serial number. To write a new value,
the password in the WSN Password parameter must be
correct.
Revision ID: Firmware revision identification.
Revision Date: Firmware revision release date.
Set Point (SPSR): Set point used during SPSR test.
SPSR Test Pause: Time interval that the SPSR test should maintain the
valve at SPSR_SP.
Stable Timeout (SPSR): Maximum time allowed for the SPSR test to finish.
Stable Time (SPSR): Measured time in which the valve took to reach and
stabilize at the SPSR_SP during last test.
9.9.3 Function Analog Output Block
9.9.3.1 Standard Parameters
BLOCK_OBJECT
Reserved Profile Parameter: This parameter is reserved and contains no relevant
data.
Block Objects: Type of related block.
Parent Class: Defines the transducer block parent class.
Class: Defines the transducer block class.
