Specialized Concentrated Focused
「
128
」
Appendix
Parameter Name
Setting Range
Default
When
Enabled
Speed/Acc
Feeding speed options
0: Use file speed
1: Use default speed
0
Immediately
G00 speed
0.06 ~ Min. value of max. speed
of each axis (mm/min)
3000
Immediately
Default feed speed
0.06 ~ Min. value of max. speed
of each axis (mm/min)
1200
Immediately
IsUseIntroSpeed
Yes: Enable; No: Disable
No
Immediately
EnterIntroSpeed
0.06 ~ Min. value of max. speed
of each axis (mm/min)
1200
Immediately
ExitIntro Speed
0.06 ~ Min. value of max. speed
of each axis (mm/min)
1200
Immediately
Speed of simulate cut
0 ~ 9000 (mm/min)
3000
Immediately
Single
axis
acceleration
in
machining
100 ~ 100000(mm/s
2
)
400
Immediately
Single
axis
acceleration
in
positioning
100 ~ 100000(mm/s
2
)
400
Immediately
Cornering acceleration
0.001 ~ 100000(mm/s
2
)
1000
Immediately
Jerk
0.001 ~ 9999999(mm/s
3
)
10000
Immediately
Jerk refers to growth rate of acceleration, i.e. the increment of acceleration in unit time, with unit
―mm/s
3
‖. It is available for S_type and LEP_type acceleration & deceleration, used to mitigate the
bad effect caused by abrupt acceleration & deceleration of machine.
Max.
angle
of
high-speed
connection
0 ~ 180(deg)
90
Immediately
During machining, if the angle of two adjacent segments are larger than ―Max. angle of high-speed
connection‖, the speed of machining joint is ―0‖; if smaller than ―Max. angle of high-speed
connection‖, an appropriate connection speed will be calculated according to the connection angle.
Interpolation algorithm
0 ~ 2
2
Immediately
0: straight line for acceleration, trapezoid speed; 1: triangle for acceleration, S-type speed; 2:
straight line for jerk, trapezoid acceleration
For trapezoid algorithm, its acceleration is a straight line and speed a trapezoid.
For S-type algorithm, its acceleration is a triangle and speed an S-type.
For acceleration trapezoid algorithm, its jerk is a straight line and acceleration a trapezoid.
The machining efficiency of trapezoid algorithm and S-type algorithm is high. When S-type
algorithm is adopted, the max. acceleration of the system can reach 2 times of single axis
acceleration set in the system. Thus, it is recommended to make down the value of parameter
―Single axis acceleration in machining‖ when S-type algorithm is selected.
Acceleration trapezoid algorithm means the curve of acceleration is a trapezoid. The relation
between acceleration and time is acceleration will increase to its max. value at jerk and then keep
constant and then decrease to ―0‖ at jerk.
