Specialized Concentrated Focused
Appendix
「
129
」
Parameter Name
Setting Range
Default
When
Enabled
Circular speed limit
Yes: Enable; No: Disable
Yes
Immediately
Only when ―Circular speed limit‖ is enabled can parameters ―Max. look-ahead paths‖, ‖Max. speed
of reference circle‖, and ―Min. speed of reference circle‖ work.
Max. speed of reference circle
Min. speed of reference circle ~
Min. value of max. speed of all
axes (mm/min)
1800
Immediately
Min. speed of reference circle
0.06 ~ Max. speed of reference
circle(mm/min)
180
Immediately
Others
Additional action when ended
0~2
0
Immediately
Additional action after machining finishes normally; for abnormal stop, this parameter does not
work. 0: None; 1: Back to fixed point; 2: Back to workpiece origin.
Min. angle of arc transition
0 ~ 175 (deg)
5
After saved
The position where the corner is smaller than the value of this parameter will not be performed
closed-angle smoothing.
Max. angle of arc transition
5 ~ 180 (deg)
175
Immediately
The position where the corner is larger than the value of this parameter will not be performed
closed-angle smoothing.
Precision of arc transition
0.001 ~ 10(mm)
0.01
Immediately
The precision for closed-angle smoothing, i.e. the length of |OD| shown in Fig. 7-7. The larger the
value is, the larger the angle of round-fillet is, the larger the error will be, while the smaller the value
is, the smaller the angle of round-fillet is, the smaller the error will be.
θ
θ
/2
O
A
B
C
D
E
Fig. 7-7 Fillet closed-angle to arc
Min. length when arc transition
0.001 ~ 1000(mm)
0.001
Immediately
Max. cut length when arc
transition
0.01 ~ 10(mm)
10
Immediately
This length is the max. length for closed-angle smoothing. As shown in Fig. 7-7, if the max.
smoothing length is |OE|, the length of |AO| should be smaller than that of |OE|.
Delay time of wait arc feedback
0~600000(ms)
10000
Immediately
Check of arc feedback signal
1: Check; 2:Uncheck
1
Immediately
CAUTION
The parameter No. of each parameter is not fixed. Under different configurations,
parameter list is slightly different. This parameter list includes all parameters
under all configurations.
