Vicon RO-M EW, User Manual

Page: 81 / 225

System settings
81
Supply voltage alarm
For good control system functioning, the voltage on the feeder cable
must be at least 10.5 volts. Switching on the alarm causes a warning
to appear on the screen if the supply voltage is lower than a value that
you have preset.

Press the field of the alarm on/off for supply voltage.
If you switch on the alarm (ticked), you can then enter the minimum
voltage value in the input field.

Press on the display of the minimum supply voltage.
The popup numeric keyboard with the value to be changed appears
on the screen.

Key in the new value on the numeric keyboard.
The new value is on the screen of the keyboard.

Confirm it or cancel it with the OK or cancel key.
The new value appears after confirmation on the screen.
Spreading disc rpm
alarm
If you have commanded the control system to start spreading, you could
have forgotten to switch on the PTO shaft. Then you waste fertiliser
and time. Switching on this alarm ensures that a warning will appear
on the screen at once should you start spreading with the stationary
spreading discs.

Press the field of the alarm spreading disc rpm on/off.
The alarm is engaged (ticked).
I
NDICATION
The alarm only checks that the spreading discs are stationary; not if
you have set the correct rpm.
Alarm lubrication
This alarm gives a warning every 8 hours that it is time to lubricate the
machine.

Press the alarm field on/off for lubricating.
S
Supply voltage alarm
S
Spreading disc rpm alarm
S
Alarm lubrication