System settings
77
TrimFlow position
If the spreader is equipped with a Trimflow, the position, working
position or transport mode can be displayed on the main screen. The
position is poorly visible from the tractor. By means of the display on
the main screen, you should make fewer spreading errors caused by
incorrect Trimflow positioning. In working position, the Trimflow
symbol appears on the main screen. In transport position, the symbol
does not appear.
Press on the display on/off area of the TrimFlow position.
The tick appears or disappears as per the TrimFlow position on the
screen.
The change is saved immediately.
Driving speed signal
The remaining system settings are in the ‘Settings’ screen.
Press the scroll key to go from the ‘Curve Calibration’ to the
‘Settings’ screen.
You must enter the source of the driving speed signal on the top line.
By means of the signal, the spreader adapts the dosing setting so that
the application rate remains the same when the driving speed
changes.
The driving speed signal can come from:
•
Simulation speed (Manual, in the Settings screen)
•
the tractor radar, (ISO Radar)
•
the wheel sensor connected to the tractor ECU, (ISO Wheel)
•
Starguide 3/4 (Starguide 3/4)
•
the GPS receiver. (GPS J1939)
In the input field for the driving speed signal source, you can choose
from the following:
•
‘Manual’, if there is no speed measurement at all. The control
system is then dealing with a fixed, input value and therefore does
not correct for changes in driving speed! You can enter the
simulated driving speed on the main screen,
•
'ISO radar'; if the signal comes from the tractor electronic unit or
radar,
•
‘ISO wheel’, if the signal comes from a speedometer connected to
the tractor ECU,
•
Starguide 3/4 where Starguide 3/4 is connected.
•
‘GPS J1939’, if the signal comes from the GPS receiver. Reception
of an external signal must of course be connected,
See section »Set ISOBUS communication« on page 88.
S
TrimFlow position
S
Actual weight in the hopper
S
Simulation speed
signal
S
Deviation reference
sensor
S
Driving speed signal from Starguide 3/4
Summary of Contents for RO-M EW
Page 42: ...Getting familiar with the machine 42 Menu structure...
Page 43: ...Getting familiar with the machine 43...
Page 218: ...Notes 218 Notes...
Page 219: ...Notes 219...
