Tiernan TDR7, Manual

Page: 127 / 226

115
Configuring the TDR7 with the Control Front Panel
Enabling and Viewing Teletext Data
If you have a TTO–6000 module installed in your TDR7, you must
enable the teletext if you want the teletext data included in the video
output stream. You enable the teletext by setting the teletext mode to
ON
.
In the steps listed below, whenever you press the
Enter
button, an
asterisk ( * ) displays and flashes for a few seconds in the upper right
corner of the LCD. When the asterisk disappears, the TDR7 has set the
parameter.
Commands required to enable teletext data along with the commands
for viewing the teletext lines and PID detected in the selected service
are shown below.
To enable teletext data:
1. If the LCD is not displaying the System menu, press the
Previous
button until the LCD displays the System menu.
2. Press the
More
button until the LCD displays the VBI menu.
3. Press the
Select
button located directly under the VBI menu.
The LCD displays the Teletext submenu.
4. Press the
More
button until the LCD displays the
Mode
submenu. The LCD displays Mode , followed by the default
setting which is Off .
5. Press the
Select
button located directly under the Off
parameter, then press the
Inc
(up) button until the LCD displays
On .
6. Press the
Enter
button to enable the teletext data.