Subaru 2009 IMPREZA, Service Manual

Page: 302 / 3619

ME(H4SO)-84
Cylinder Block
MECHANICAL
(5) Apply liquid gasket to the three bolts thread
shown in figure. (when reusing bolts)
Liquid gasket:
THREE BOND 1324 (Part No. 004403042) or
equivalent
Tightening torque:
T: 6.4 N·m (0.7 kgf-m, 4.7 ft-lb)
32) Install the water pump and gasket.
NOTE:
• When installing the water pump, tighten bolts in
two stages in alphabetical order as shown in the
figure.
• Use a new gasket.
Tightening torque:
First: 12 N·m (1.2 kgf-m, 8.9 ft-lb)
Second: 12 N·m (1.2 kgf-m, 8.9 ft-lb)
33) Install the water by-pass pipe for heater.
Tightening torque:
6.4 N·m (0.7 kgf-m, 4.7 ft-lb)
34) Install the oil filter.
<Ref. to LU(H4SO)-21, INSTALLATION, Engine
Oil Filter.>
35) Install the cylinder head. <Ref. to ME(H4SO)-
64, INSTALLATION, Cylinder Head.>
36) Install the generator and A/C compressor with
their brackets.
Tightening torque:
36 N·m (3.7 kgf-m, 26.6 ft-lb)
37) Install the crank sprocket. <Ref. to ME(H4SO)-
56, INSTALLATION, Crank Sprocket.>
38) Install the timing belt. <Ref. to ME(H4SO)-50,
INSTALLATION, Timing Belt.>
39) Adjust the valve clearance. <Ref. to
ME(H4SO)-29, ADJUSTMENT, Valve Clearance.>
40) Install the rocker cover.
(1) Install the rocker cover gasket to the rocker
cover.
NOTE:
Use a new rocker cover gasket.
(2) Temporarily tighten the bolts in alphabetical
order shown in the figure, tighten them in two
stages.
Tightening torque:
First
6.4 N·m (0.7 kgf-m, 4.7 ft-lb)
Second (only (a) and (b) are tightened)
6.4 N·m (0.7 kgf-m, 4.7 ft-lb)
RH side
LH side
41) Install the timing belt cover. <Ref. to
ME(H4SO)-48, INSTALLATION, Timing Belt Cov-
er.>
42) Install the crank pulley. <Ref. to ME(H4SO)-46,
INSTALLATION, Crank Pulley.>
43) Install the intake manifold. <Ref. to FU(H4SO)-
18, INSTALLATION, Intake Manifold.>
44) Install the V-belts. <Ref. to ME(H4SO)-39, IN-
STALLATION, V-belt.>
LU-02103
T
ME-02463
(F)
(E)
(D)
(C)
(B)
(A)
ME-02715
(a)
(b)
(c)
(d)
(e)
(f)
ME-02716
(a)
(b)
(c)
(d)
(e)
(f)