Subaru 2009 IMPREZA, Service Manual

Page: 3164 / 3619

SR-7
Sunroof Motor
SUNROOF/T-TOP/CONVERTIBLE TOP (SUNROOF)
5. Sunroof Motor
A: REMOVAL
CAUTION:
Never rotate the motor assembly after remov-
ing it.
1) Completely close the glass lid.
2) Disconnect the ground cable from battery.
3) Remove the spot map light. <Ref. to LI-30, RE-
MOVAL, Spot Map Light.>
4) Remove the motor assembly.
CAUTION:
When removing the motor assembly, secure
the cable wires to prevent moves.
(1) Disconnect the harness connector (A).
(2) Remove the attachment screw (B).
B: INSTALLATION
CAUTION:
When installing the motor assembly, be careful
not to move the sunroof cable.
1) Install in the reverse order of removal.
2) Perform the initialize operation of motor.
(1) Tilt up the glass lid.
(2) Release the switch once, and press the tilt
up switch again for 15 seconds.
(3) When the glass lid is raised a little and on tilt
up position, release the switch for the moment.
(4) Keep pressing the tilt up switch within 5 sec-
onds from releasing the switch, glass lid auto-
matically performs the tilts down
o
slides open
o
slides close operation, then the initialize op-
eration is completed.
3) Check the operation of sunroof with following ta-
ble.
Operation Switch position
(1) Glass lid closes completely. Close
(2) Glass lid tilt up to the top position. Tilt up
(3) Glass lid closes completely. Tilt down
(4) Glass lid opens completely. Open
(5) Glass lid closes completely. Close
(A)
(B)
SR-00156