Subaru 2009 IMPREZA, Service Manual

Page: 2610 / 3619

BR-43
Brake Pedal
BRAKE
5) Remove the bolt and nut which secures the
brake pedal bracket.
B: INSTALLATION
CAUTION:
• Perform the following steps for the stop light
switch.
• Do not install the stop light switch before
step 2). Installing the stop light switch before
step 2) may result in the switch falling off, re-
maining illuminated constantly, or an illumina-
tion fault.
1) Install the bolt and nut which secure the brake
pedal bracket.
Tightening torque:
18 N·m (1.8 kgf-m, 13.3 ft-lb)
2) Install clevis pin and snap pin which secure the
operating rod to the brake pedal.
NOTE:
• Replace with a new clevis pin.
• Apply a thin coat of KOPR-KOTE (Part No.
003603001) to the clevis pin.
3) Make sure that the switch clip (gray) is securely
installed to the brake pedal bracket.
4) While pulling up the brake pedal, insert the stop
light switch until it reaches the stopper (brown) at
the brake pedal side. Turn the stop light switch
clockwise and install the switch.
5) Connect the stop light switch connector.
6) Check that the brake light operate properly.
7) Check the brake pedal after installation. <Ref. to
BR-44, INSPECTION, Brake Pedal.>
(1) Clevis pin
(2) Snap pin
(3) Operating rod
(4) Brake pedal
BR-00687
(1)
(3)
(4)
(2)
BR-00686
(1) Switch clip
(2) Brake pedal bracket
(1) Stop light switch
(2) Stopper
BR-00680
(1)
(2)
BR-00681
(1)
(2)
BR-00674