Subaru 2009 IMPREZA, Service Manual

Page: 1843 / 3619

CS-26
Select Cable
CONTROL SYSTEMS
B: INSTALLATION
1) Install the select cable to plate assembly.
Tightening torque:
18 N·m (1.8 kgf-m, 13.3 ft-lb)
2) Install the select cable to the shifter arm.
3) Install the plate assembly to transmission.
Tightening torque:
T: 25 N·m (2.5 kgf-m, 18.4 ft-lb)
4) Install the washer and snap pin to the shifter
arm.
5) Install new clamp paying attention to the install-
ing direction.
6) Insert the tip of inner cable into connector hole of
select lever, and fix the cable to bracket.
7) Shift the select lever to the “N” range, and then
adjust the select cable position. <Ref. to CS-27,
ADJUSTMENT, Select Cable.>
8) Install the heat shield cover.
9) Install the front, center and rear exhaust pipes,
and the muffler. (Non-turbo model) <Ref. to
EX(H4SO)-7, INSTALLATION, Front Exhaust
Pipe.> <Ref. to EX(H4SO)-9, INSTALLATION,
Center Exhaust Pipe.> <Ref. to EX(H4SO)-10, IN-
STALLATION, Rear Exhaust Pipe.> <Ref. to
EX(H4SO)-12, INSTALLATION, Muffler.>
10) Install the center, rear exhaust pipes and the
muffler. (Turbo model) <Ref. to EX(H4DOTC)-10,
INSTALLATION, Center Exhaust Pipe.> <Ref. to
EX(H4DOTC)-13, INSTALLATION, Rear Exhaust
Pipe.> <Ref. to EX(H4DOTC)-15, INSTALLATION,
Muffler.>
(A) Select cable
(B) Plate ASSY
(A) Shifter arm
(B) Snap pin
(C) Select cable
(D) Bracket
(E) Washer
CS-00607
T
T
CS-00956
(B)
(A)
T
CS-00954
(C)
(A)
(B)
(E)
(D)
(A) Clamp
(B) Forward
CS-00329
C
C
(A)
(B)
CS-00330
AT-04522