Subaru 2009 IMPREZA, Service Manual

Page: 3141 / 3619

SL-37
Rear Door Latch and Door Lock Actuator Assembly
SECURITY AND LOCKS
10.Rear Door Latch and Door
Lock Actuator Assembly
A: REMOVAL
1) Disconnect the ground cable from battery.
2) Remove the rear door trim. <Ref. to EI-43, RE-
MOVAL, Door Trim.>
3) Remove the wire from the rear inner remote.
<Ref. to SL-35, REMOVAL, Rear Inner Remote.>
4) Remove the sealing cover. <Ref. to EB-25, RE-
MOVAL, Rear Sealing Cover.>
5) Remove the rear door glass. <Ref. to GW-18,
REMOVAL, Rear Door Glass.>
6) Disconnect the harness connector.
7) Remove the three screws, and remove the rear
door latch and door lock actuator assembly.
B: INSTALLATION
Install in the reverse order of removal.
Tightening torque:
Refer to “COMPONENT” of “General Descrip-
tion”. <Ref. to SL-2, DOOR LOCK ASSEM-
BLY, COMPONENT, General Description.>
C: INSPECTION
1. DOOR LATCH
1) Check the cable for deformation. When it is de-
formed, straighten it because failure operations
may occur. When it is unrepairable, replace the
rear door latch and door lock actuator assembly.
2) Check the lever and wire for smooth operation.
2. LOCK ACTUATOR
1) Disconnect the door lock actuator harness con-
nector.
2) Connect the battery to door lock actuator termi-
nals.
If defective, replace the rear door latch and door
lock actuator assembly.
SL-00738
Actuator operation
Terminals
No. 1 No. 2
Lock
o
Unlock – +
Unlock
o
Lock + –
2 1
SL-00765