Subaru 2009 IMPREZA, Service Manual

Page: 1940 / 3619

4AT-84
Converter Case
AUTOMATIC TRANSMISSION
B: INSTALLATION
1) Check the appearance of each component and
clean them.
2) Press-fit the new oil seal to converter case using
ST.
ST
398437700 DRIFT
3) Install the front differential assembly to the case.
<Ref. to 4AT-98, INSTALLATION, Front Differen-
tial Assembly.>
4) Install the right and left side retainers. <Ref. to
4AT-102, ADJUSTMENT, Front Differential As-
sembly.>
5) Install new seal pipe to converter case.
6) Install new rubber seal to converter case.
7) Apply proper amount of liquid gasket to the en-
tire matching surface of converter case.
Liquid gasket:
THREE BOND 1215 (Part No. 004403007) or
equivalent
8) Install the converter case, being careful not to
damage the bushing and oil seal.
NOTE:
Use new bolts for the oil charge pipe.
Tightening torque:
Oil charge pipe section
38 N·m (3.9 kgf-m, 28.0 ft-lb)
Excluding the oil charge pipe section
41 N·m (4.2 kgf-m, 30.2 ft-lb)
9) Insert the inhibitor switch connector and trans-
mission harness connector onto the stay.
10) Install the air breather hose. <Ref. to 4AT-67,
INSTALLATION, Air Breather Hose.>
11) Install the ATF cooler pipe. <Ref. to 4AT-65, IN-
STALLATION, ATF Cooler Pipe and Hose.>
12) Install the oil charge pipe with O-ring. <Ref. to
4AT-68, INSTALLATION, Oil Charge Pipe.>
(A) Seal pipe
(A) Rubber seal
AT-00177
AT-00176
AT-00178
(A)
(A) THREE BOND 1215
(B) Rubber seal
(B)
(A)
AT-00179
AT-04678