Subaru 2009 IMPREZA, Service Manual

Page: 2134 / 3619

5MT-62
Drive Pinion Shaft Assembly
MANUAL TRANSMISSION AND DIFFERENTIAL
8) Position the woodruff key in groove of the rear of
driven shaft. Install the 5th driven gear onto driven
shaft using ST and a press.
CAUTION:
Do not apply a load in excess of 10 kN (1 ton, 1.1
US ton, 1.0 Imp ton).
ST 499277200 INSTALLER
9) Install the lock washer. Tighten the lock nuts to
the specified torque using ST1 and ST2.
ST1
499987300 SOCKET WRENCH (50)
ST2 899884100 HOLDER
Tightening torque:
260 N·m (26.5 kgf-m, 191.8 ft-lb)
NOTE:
• Crimp the locknut in 2 locations.
• Using a spring scale, check that starting torque
of the roller bearing is 0.1 to 1.5 N (0.01 to 0.15 kgf,
0.02 to 0.34 lbf).
10) Install the roller bearing onto the drive pinion
shaft.
NOTE:
When installing the roller bearing, note its direc-
tions (front and rear) because the knock pin hole of
outer race is offset.
11) Install the washer using ST1, ST2 and a press.
CAUTION:
Do not apply a load in excess of 10 kN (1 ton, 1.1
US ton, 1.0 Imp ton).
ST1 499277100 BUSHING 1-2 INSTALLER
ST2 499277200 INSTALLER
12) Install the thrust bearing and needle bearing.
Install the driven shaft assembly.
MT-00257
ST
MT-00258
ST
MT-00259
(A) Roller bearing
(B) Knock pin hole
(A) Washer
MT-00260
(A)
(B)
MT-00261
(A)
ST1
ST2
MT-00262