Subaru 2009 IMPREZA, Service Manual

Page: 1897 / 3619

4AT-41
Automatic Transmission Assembly
AUTOMATIC TRANSMISSION
11) Install the torque converter clutch assembly to
the drive plate.
CAUTION:
• Be careful not to damage the mounting bolts.
• Be careful not to drop bolts into the converter
case.
(1) Tighten the bolts which hold the torque con-
verter clutch to the drive plate.
(2) Place the wrench on the crank pulley bolt,
and remove all the bolts while rotating the crank
pulley a little bit at a time.
Tightening torque:
25 N·m (2.5 kgf-m, 18.4 ft-lb)
(3) Fit the plug to service hole.
(4) Install the V-belt cover.
12) Remove the ST.
13) Install the engine harness bracket. (Non-turbo
model)
Tightening torque:
T: 16 N·m (1.6 kgf-m, 11.8 ft-lb)
14) Install the harness connector to engine harness
bracket, then connect the harness. (Non-turbo
model)
15) Install the engine hanger. (Turbo model)
16) Install the pitching stopper bracket.
Tightening torque:
41 N·m (4.2 kgf-m, 30.2 ft-lb)
17) Install the throttle body. (Non-turbo model)
<Ref. to FU(H4SO)-14, INSTALLATION, Throttle
Body.>
18) Install the pitching stopper.
Tightening torque:
T1: 50 N·m (5.1 kgf-m, 36.9 ft-lb)
T2: 58 N·m (5.9 kgf-m, 42.8 ft-lb)
19) Lift up the vehicle.
20) Replace the circlip of the front drive shaft with a
new part.
21) Apply grease to the oil seal lip.
AT-00102
AT-02167
ST
AT-04581
AT-04582
AT-04642
(A)
AT-04524
T2
T1