Subaru 2009 IMPREZA, Service Manual

Page: 1841 / 3619

CS-24
Select Lever
CONTROL SYSTEMS
D: ASSEMBLY
1) Clean all the parts before assembly.
2) Apply NIGTIGHT LYW No. 2 grease or equiva-
lent to each part. <Ref. to CS-3, AT SELECT LE-
VER, COMPONENT, General Description.>
3) Assemble in the reverse order of disassembly.
NOTE:
• Set the select lever to “D” range (normal mode
position) when installing the guide plate and be
careful of the following.
• Insert the protrusion (B) of the guide plate into
the hole on shift lock solenoid unit (A).
• Insert link (D) of the shift lock release into link
(C) of the shift lock solenoid unit.
• Connect the switch and solenoid terminals to the
connector.
4) After completing installation, shift the select le-
ver from “P” range to “D” range, then check wheth-
er the indicator and select lever matches, whether
the pointer and position mark matches and whether
the operating force occurs.
E: INSPECTION
1) Inspect the removed parts by comparing with
new parts for deformation, damage and wear. Re-
pair or replace if defective.
2) Confirm the select lever operating condition be-
fore assembly. Normal if it operates smoothly.
b
(D)
(C)
(B)
a
a
b
(A)
CS-00952
(A) “P” range switch (color code: white)
(B) “P” range switch (color code: black)
(C) Shift lock solenoid (color code: blue/red)
(D) Shift lock solenoid (color code: black)
(E) SPORT mode switch (color code: white)
(F) SPORT mode switch (color code: black)
CS-00386
(D)
3 4
9 10
1 2
6 5 7 8
(C)
(E) (F)
(B) (A)