Subaru 2009 IMPREZA, Service Manual

Page: 1838 / 3619

CS-21
Select Lever
CONTROL SYSTEMS
17) Disconnect the connectors, and then remove
the four bolts to take out the select lever assembly
from vehicle body.
B: INSTALLATION
1) Set the select lever to vehicle body.
2) Tighten the four bolts to install the select lever to
vehicle body, and then connect the connector.
(1) Temporarily tighten the bolt A.
(2) Tighten the bolt B.
(3) Tighten the bolt A.
(4) Tighten the bolts C and D.
Tightening torque:
18 N·m (1.8 kgf-m, 13.3 ft-lb)
3) Install the harness clips to the bracket.
4) Install the console cover and console box. <Ref.
to EI-48, INSTALLATION, Console Box.>
5) Shift the select lever to “N” range.
6) Install the blind.
CAUTION:
The blind should be installed so that it is se-
curely caught by tabs of the plate guide COM-
PL.
7) Install the indicator assembly.
8) Install the console front panel.
9) Install the hand brake boot cover.
10) Install the grip.
11) Lift up the vehicle.
12) Shift the range select lever to “N” range.
13) Secure the cable to the bracket. <Ref. to CS-
26, INSTALLATION, Select Cable.>
14) Adjust the select cable position. <Ref. to CS-
27, ADJUSTMENT, Select Cable.>
15) After the completion of adjustment, confirm that
the select lever operates properly at all range posi-
tions.
16) Install the heat shield cover.
17) Install the rear exhaust pipe and muffler.
• Non-turbo model
<Ref. to EX(H4SO)-10, INSTALLATION, Rear Ex-
haust Pipe.> <Ref. to EX(H4SO)-12, INSTALLA-
TION, Muffler.>
• Turbo model
<Ref. to EX(H4DOTC)-13, INSTALLATION, Rear
Exhaust Pipe.> <Ref. to EX(H4DOTC)-15, IN-
STALLATION, Muffler.>
18) Inspect the following items. When a malfunc-
tion is found in the inspection, adjust the select ca-
ble and inhibitor switch. <Ref. to CS-27,
ADJUSTMENT, Select Cable.> <Ref. to 4AT-48,
ADJUSTMENT, Inhibitor Switch.>
(1) Engine starts when the select lever is in “P”
and “N” range, but not in other ranges.
(2) Back-up light illuminates when the select le-
ver is in the “R” range, but not in other ranges.
(3) Select lever and indicator positions are
matched.
CS-00881
D
A
B
CS-00887
C
CS-00897
AT-04522