Subaru 2009 IMPREZA, Service Manual

Page: 3138 / 3619

SL-34
Front Door Latch and Door Lock Actuator Assembly
SECURITY AND LOCKS
7. Front Door Latch and Door
Lock Actuator Assembly
A: REMOVAL
1) Raise the front door glass to the top position.
2) Disconnect the ground cable from battery.
3) Remove the front door trim. <Ref. to EI-43, RE-
MOVAL, Door Trim.>
4) Remove the sealing cover. <Ref. to EB-22, RE-
MOVAL, Front Sealing Cover.>
5) Remove the glass run rubber (A) partially.
6) Remove the rear sash.
7) Remove the rod from the outer handle rod
clamp.
8) Disconnect the harness connector.
9) Remove the three screws, and then remove the
front door latch and door lock actuator assembly.
B: INSTALLATION
Install in the reverse order of removal.
Tightening torque:
Refer to “COMPONENT” of “General Descrip-
tion”. <Ref. to SL-2, DOOR LOCK ASSEM-
BLY, COMPONENT, General Description.>
C: INSPECTION
1. DOOR LATCH
1) Check the rod, door opener and door lock cable
for deformation. When it is deformed, straighten it
because failure operations may occur. When it is
unrepairable, replace the front door latch and door
lock actuator assembly.
2) Check the lever, rod and wire for smooth opera-
tion.
2. LOCK ACTUATOR
1) Disconnect the door lock actuator harness con-
nector.
2) Connect the battery to door lock actuator termi-
nals.
If defective, replace the front door latch and door
lock actuator assembly.
SL-00886
(A)
SL-00736
Actuator operation
Terminals
No. 1 No. 2
Lock
o
Unlock – +
Unlock
o
Lock + –
2 1
SL-00765