Subaru 2009 IMPREZA, Service Manual

Page: 2642 / 3619

PS-19
Steering Gearbox
POWER ASSISTED SYSTEM (POWER STEERING)
5) Connect pipe D to the return hose, then connect
pipe C to the pressure hose.
Tightening torque:
15 N·m (1.5 kgf-m, 11.1 ft-lb)
6) Install the universal joint. <Ref. to PS-13, IN-
STALLATION, Universal Joint.>
7) Connect the tie-rod end and knuckle arm, and
tighten with castle nut.
Castle nut tightening torque:
27 N·m (2.8 kgf-m, 19.9 ft-lb)
CAUTION:
When connecting, do not hit the cap at the bot-
tom of tie-rod end with hammer.
8) After tightening the castle nut to the specified
tightening torque, tighten it further within 60° until
the cotter pin hole is aligned with slot in the nut. Fit
the cotter pin into the nut, and then bend the pin to
lock.
9) Install the front stabilizer. <Ref. to FS-16, IN-
STALLATION, Front Stabilizer.>
10) Install the front crossmember support plate and
jack-up plate.
11) Install the front exhaust pipe assembly. (Non-
turbo model) <Ref. to EX(H4SO)-7, INSTALLA-
TION, Front Exhaust Pipe.>
12) Install the under cover. <Ref. to EI-26, INSTAL-
LATION, Front Under Cover.>
13) Install the front wheels.
14) Tighten the wheel nuts to the specified torque.
Tightening torque:
100 N·m (10.2 kgf-m, 73.8 ft-lb)
15) Lower the vehicle.
16) Remove the steering wheel. <Ref. to PS-12,
REMOVAL, Steering Wheel.>
17) Align the center position of the roll connector.
<Ref. to AB-26, ADJUSTMENT, Roll Connector.>
18) Install the steering wheel. <Ref. to PS-12, IN-
STALLATION, Steering Wheel.>
19) Connect the ground cable to battery.
20) Pour fluid into the oil tank, and bleed air. <Ref.
to PS-50, Power Steering Fluid.>
21) Check for fluid leaks.
22) Check the fluid level in oil tank.
(1) Pipe C
(2) Pipe D
(3) Pressure hose
(4) Return hose
PS-00538
(4)
(3)
(2)
(1)
(A) Cotter pin
(B) Castle nut
(C) Tie-rod end
DS-00042
(C)
(B)
(A)