Subaru 2009 IMPREZA, Service Manual

Page: 1986 / 3619

4AT-130
Transmission Control Device
AUTOMATIC TRANSMISSION
2) Insert the range select lever, and tighten the
bolts.
Tightening torque:
6 N·m (0.6 kgf-m, 4.4 ft-lb)
3) Insert the manual plate and parking rod.
4) Insert a new spring pin into the manual plate.
5) Install the oil pan and the control valve assem-
bly. <Ref. to 4AT-59, INSTALLATION, Control
Valve Body.>
6) Turn over the transmission case to its original
position.
7) Install the pitching stopper bracket.
Tightening torque:
41 N·m (4.2 kgf-m, 30.2 ft-lb)
8) Install and adjust the inhibitor switch. <Ref. to
4AT-48, Inhibitor Switch.>
9) Insert the inhibitor switch connector and trans-
mission harness connector onto the stay.
10) Install the air breather hose. <Ref. to 4AT-67,
INSTALLATION, Air Breather Hose.>
11) Insert the input shaft while rotating it lightly by
hand, and then check the amount of protrusion.
Normal protrusion A:
50 — 55 mm (1.97 — 2.17 in)
12) Install the torque converter clutch assembly.
<Ref. to 4AT-69, INSTALLATION, Torque Convert-
er Clutch Assembly.>
13) Install the transmission assembly to the vehi-
cle. <Ref. to 4AT-40, INSTALLATION, Automatic
Transmission Assembly.>
C: INSPECTION
Make sure that the manual lever and detent spring
are not worn or otherwise damaged.
(A) Bolt
(B) Range select lever
(C) Manual plate
(D) Parking rod
AT-04849
AT-04845
(B)
(C)
(D)
(A)
AT-04847
(A) Transmission harness connectors
(B) Inhibitor switch connector
A Measured value
AT-01351
(B)
(A)
A
AT-02384