Subaru 2009 IMPREZA, Service Manual

Page: 3014 / 3619

WW-19
Rear Wiper Motor
WIPER AND WASHER SYSTEMS
10.Rear Wiper Motor
A: REMOVAL
1) Disconnect the ground cable from the battery.
2) Remove the rear wiper arm. <Ref. to WW-18,
REMOVAL, Rear Wiper Arm.>
3) Remove the rear gate lower trim. <Ref. to EI-66,
REMOVAL, Rear Gate Trim.>
4) Disconnect the harness connector of wiper mo-
tor assembly.
5) Remove the bolt, and then remove the wiper mo-
tor assembly.
B: INSTALLATION
1) Install in the reverse order of removal.
2) Make sure that the pivot cap with the round mark
facing up, as shown in the figure.
Tightening torque:
Refer to “COMPONENT” of “General Descrip-
tion”. <Ref. to WW-3, REAR WIPER, COMPO-
NENT, General Description.>
C: INSPECTION
1) Connect the battery to the wiper motor connec-
tor and confirm that wiper motor operates.
2) Connect the battery to terminals of the connec-
tor, and remove the terminal connection with motor
rotating, and stop the wiper motor in mid-operation.
3) Connect the battery and confirm that the motor
stops at the automatic stop position after the motor
operates at low speed again.
WW-00492
WW-00545
WW-00508
2 1
4 3
WW-00509
2 1
4 3
WW-00510
2 1
4 3