Subaru 2009 IMPREZA, Service Manual

Page: 2137 / 3619

5MT-65
Drive Pinion Shaft Assembly
MANUAL TRANSMISSION AND DIFFERENTIAL
3) After removing the ST2, measure the starting
torque using torque driver.
ST1
899884100 HOLDER
ST3 899988608 SOCKET WRENCH (27)
Starting torque:
0.3 — 0.8 N·m
(0.03 — 0.08 kgf-m, 0.22 — 0.59 ft-lb)
4) If the starting torque is not within the specified
limit, select new adjusting washer No. 1 and re-
check starting torque.
5) If the specified starting torque cannot be ob-
tained by the selection of adjusting washer No. 1,
select adjusting washer No. 2 from the list below.
Repeat steps 1) through 4) to adjust starting
torque.
6) Recheck that the starting torque is within the
specified range, then crimp the lock nut at four po-
sitions.
(A) Adjusting washer No. 1
(B) Adjusting washer No. 2
Adjusting washer No. 1
Part No. Thickness mm (in)
803025051 3.925 (0.1545)
803025052 3.950 (0.1555)
803025053 3.975 (0.1565)
803025054 4.000 (0.1575)
803025055 4.025 (0.1585)
803025056 4.050 (0.1594)
803025057 4.075 (0.1604)
MT-00269
ST1
ST3
MT-00270
( A )
( B )
(A) Adjusting washer No. 1
(B) Adjusting washer No. 2
Starting torque Dimension H Adjusting washer No. 2
Low Small Select thicker one.
High Large Select thinner one.
Adjusting washer No. 2
Part No. Thickness mm (in)
803025059 3.850 (0.1516)
803025054 4.000 (0.1575)
803025058 4.150 (0.1634)
MT-00270
( A )
( B )