Subaru 2009 IMPREZA, Service Manual

Page: 2956 / 3619

SB-17
Front Seat Belt
SEAT BELT SYSTEM
5. Front Seat Belt
A: REMOVAL
1. OUTER SEAT BELT ASSEMBLY
CAUTION:
• Do not drop or subject the pretensioner to
any impact.
• Since the pretensioner and bracket are inte-
grated as a unit, do not disassemble them.
1) Before starting the work, turn the ignition switch
to OFF, disconnect the battery ground cable, and
wait for 20 seconds or more.
2) Fold the backrest all the way forward, and then
move the front seat all the way forward.
3) Remove the center pillar lower trim. <Ref. to EI-
55, REMOVAL, Lower Inner Trim.>
4) Remove the anchor cover (A).
5) Loosen the shoulder anchor bolt (B), and then
detach the shoulder anchor from center pillar.
6) Turn over the floor mat and disconnect the pre-
tensioner connector (A).
7) Remove the bolts, then remove the front outer
seat belt.
8) Remove the center pillar upper trim. <Ref. to EI-
57, REMOVAL, Upper Inner Trim.>
9) Remove the bolts and then remove adjustable
anchor assembly.
2. INNER SEAT BELT ASSEMBLY
1) Turn the ignition switch to OFF, disconnect the
battery ground cable, and wait for 20 seconds or
more.
2) Remove the front seats. <Ref. to SE-6, REMOV-
AL, Front Seat.>
3) Disconnect the seat belt warning light connector
under the seat.
4) Remove the seat belt harness from the harness
holder on the backside of seat cushion assembly.
5) Remove the TORX
®
bolt, and then remove the
inner seat belt assembly.
B: INSTALLATION
CAUTION:
• The parts of the driver and passenger sides
are not the same. Before installation, make sure
that the correct part is used.
• Be careful not to twist the seat belts during
installation.
Install in the reverse order of removal.
Tightening torque:
Seat belt:<Ref. to SB-2, FRONT SEAT BELT,
COMPONENT, General Description.>
Upper inner trim: 7.5 N·m (0.76 kgf-m, 5.5 ft-
lb)
SB-00350
(A)
(B)
(A)
SB-00351
SB-00352
SE-00332