Subaru 2009 IMPREZA, Service Manual

Page: 3349 / 3619

LAN(diag)-16
Subaru Select Monitor
LAN SYSTEM (DIAGNOSTICS)
3. DISPLAY OF ANALOG DATA
Items to be displayed Unit of measure Remarks Note
BATT voltage (control) 10 — 15 V
Body integrated unit input
value
Always
BATT voltage (BACKUP) 10 — 15 V
Body integrated unit input
value
Always
IG power supply voltage 10 — 15 V
Body integrated unit input
value
Ignition switch ON
ACC voltage 10 — 15 V
Body integrated unit input
value
Ignition switch ACC
Illumination VR Voltage 0 — 5 V
Body integrated unit input
value
Input value from illumination volume
Illumi. output d-ratio 0 — 100%
Body integrated unit out-
put value
Small light ON
Illumination volume is other than bright.
Ambient Temperature –40 — 87.5°C CAN data input value Ignition switch ON
Fuel level voltage 0 — 10 V
Body integrated unit input
value
Ignition switch ON
Fuel level resistance 0 — 102.3
:
Body integrated unit input
value
Ignition switch ON
key-lock solenoid V 6 — 15 V
Body integrated unit out-
put value
Key warning switch ON, other than park-
ing range
Ignition switch ON
number of regist. 0 — 4
Number of keyless key
registered
Number of transmitter registered is dis-
played
Front Wheel Speed km/h CAN data input value Reception from VDC module
VDC/ABS latest f-code
DTC display (Tempo-
rarily)
CAN data input value
It is normal when DTC is not been input
even if this code is displayed.
Received from VDC (displayed by hexa-
decimal number system)
Blower Fan Steps 0 — 2 levels CAN data input value
0: OFF, 1: Low, 2: 2 levels or more
Reception from air conditioner ECM
Fuel level resistance 2 0 — 102.3
:
CAN data output value Reception from body integrated unit
Fuel consumption cc/s CAN data input value
Reception from ECM and transmission
to center monitor
Coolant Temp. –40 — 130°C CAN data input value Reception from ECM
Vehicle longitudinal G m/s
2
CAN data input value Reception from VDC module
SPORT Shift Stages 0 — 7 levels CAN data input value
(0: Light OFF; 1 — 5: Gear display; 6:
Fail; 7: ATF temperature High/Low)
Reception from TCM
Shift Position 0 — 7 levels CAN data input value
0: 1, 1: 2, 2: 3, 3: 4, 4: D, 5: N, 6: R, 7: P
shift position (8 indicates no input)
8 is displayed in manual mode
Reception from TCM
VDC/ABS condition 0 — 4 CAN data input value Reception from VDC module
Destination Code 0 — 16 CAN data input value Reception from combination meter
Touch SW 0 — 64 CAN data input value Reception from navigation unit