5-20
Settings Functions
Explanations
7
Acceleration/deceleration
Speed Inhibit
When the acceleration/deceleration speed
inhibition function is executed, the drive will stop
the acceleration/deceleration immediately; the
drive will go on with the acceleration/deceleration
from where it stopped earlier after this command is
removed
8
The
1
st
, 2
nd
acceleration or
deceleration time selection
9
The 3
rd
, 4
th
acceleration or
deceleration time selection
The acceleration/deceleration time of the drive
could be selected from this function or the digital
statuses
of
the
terminals;
there
are
4
acceleration/deceleration speeds in total for
selection.
10
EF Input
External fault input terminal
11
Disable
Vector(stop)
12
B.B. traces from the bottom
upward
13
B.B. traces from the top
downward
If the ON/OFF function of the terminal is
pre-determined, output of the drive will be cut off
immediately, and the motor will then be of the B.B.
status. And once the ON/OFF function is
restored, the drive will then trace from the bottom
upward to catch up with its mutual rotation speed
with the same frequency before B.B., then speed
up to the pre-set frequency. Even if the motor is
of a complete stop after B.B., as long as the
ON/OFF status is restored, the speed-tracing
function could still be operated.
14
Cancel the setting of the optimal acceleration/deceleration time
15
Switch between drive settings
1 and 2
Used in the vector control
16
Operation speed command
from AVI
17
Operation speed command
from ACI
18
Operation speed command
from AUI
19
Emergency Stop
20
Digital Up command
Refer to Pr. 02-07
Summary of Contents for S3000 Series
Page 8: ...2 5 DIMENTIONS 2 5...
Page 9: ...2 6 403 216...
Page 10: ...2 7...
Page 11: ...2 8 S3000 IP06...
