SANCH S3000 Series, User Manual

Page: 42 / 139

4-25
Group 7: Special Parameter
Parameters Functions Settings
Factory
Setting
Customer
07-00 Software Braking Level
700.0~900.0V 760.0
07-01 DC Braking Current Level 0~100% 0
07-02 DC Braking Time at Start-up 0.00~60.00 s 0.00
07-03
DC Braking Time during a
STOP
0.00~60.00 s 0.00
07-04
Frequency point for DC
Braking
0.00~400.00Hz 0.00
07-05
Increasing Rate of the DC
Voltage
1~500 30
07-06
Re-activate after Momentary
Power Loss
0: disable
1: begins from command
frequency
2: begins from minimum
output frequency
0
07-07
Maximum Allowable Power
Loss Time
0.1~5.0 s 2.0
07-08
Base Block Time for Speed
Search
0.1~5.0 s 0.5
07-09
Maximum Current Level for
Speed Search
20~200% 150
07-10
Deceleration Time for Speed
Search
0.50~600.00 s 3.00
07-11 Auto Restart after Fault 0~10 0
07-12 Speed Search Type
0: speed search disabled
1: speed search through
the frequency command
2: FWD-speed search only
(motor only runs in FWD
direction)
3: REV-speed search only
(motor only runs in REV
direction)
4: FWD/REV speed search
enabled in both
directions (fwd first)
5: REV/FWD speed search
enabled in both
directions (rev first)
0
07-13
Speed Search Frequency
(FWD direction)
0.00~400.00Hz
60.00/
50.00
07-14
Speed Search Frequency
(REV direction)
0.00~400.00Hz
60.00/
50.00
07-15
Gear Gap
Acceleration-Interruption Time
0.00~400.00 s 0.00