Ricoh AFICIO AP306, Setup Manual

Page: 372 / 382

Draft 2000/06/22
Appendix
98
6
❖
When using SNMP
Error numbers in the messages are codes for internal use.
Exit snmpd The agent is complete. Reset the printer
or turn the printer off and on.
recvfrom:packet discarded,length(Re-
ception packet length)> (Packet
size),from addr <Address of partner
point> The received packet was ignored since
the length of the packet exceeds the lim-
it. Confirm whether the administration
station sent a packet is longer than 1025
bytes.
session <Community name appointed>
not defined The community name of the received
packet is not defined. Confirm that the
community name of the administration
station is the same as that specified for
the printer.
snmpin:Bad use of session <community
Name> from <Address> The community name of the received
packet is not the same as that of the ad-
ministration station. Confirm the com-
munity name specified to the printer.
snmpin:error in snmpdecipher,code
(<Error No.>) An error occurred with the received
packet. Check if the number of the ob-
jects sent from the administration sta-
tion is more than 31 and if there are
wrong MIB requests.
snmpin:error in snmpservsend,code
(<Error No.>) Cannot send a response packet. Nor-
mally, this message is followed by the
messages below *1 *2.
snmpin:pkt too large,code (<Error num-
ber>)
*1
The response packet to the request is too
big to send. Reduce the number of the
objects per request.
snmpin:error in sending too large re-
quest back,code (<Error number>),giv-
ing up
*2
The packet notifying the error is too big
to send. Reduce the number of the ob-
jects per request.
snmpin:received bad version The version of the received packet is in-
valid. Confirm that the version of the
administration station is version-1(0).