Ricoh AFICIO AP306, Setup Manual

Page: 47 / 382

Draft 2000/06/22
Configuring the Printer for the Network with the Operation Panel
27
3
Check if the pointer (
U
) is at the
rightmost digit, press
{
Enter
}
to
register the IP address you spec-
ified.
<System Menu>
j
32.IP Address
l
F
If you use TCP/IP, you should as-
sign “33.Subnet Mask”, “34.Gate-
way Add”, “35.Access CTL.” and
“36.Access Mask” using the same
procedure for specifying the IP
address.
⇒
P.28 “Address”
G
If you use TCP/IP, you can make
settings for “Network Boot”.
You can select how to assign the
printer's address using the com-
puter. Select one of the items on
the following table.
*1
ARP+PING
*2
RARP+TFTP
*3
BOOTP
*4
DHCP
Note
❒
You should set up the server, if
you want to use “RARP+TFTP”,
“BOOTP” or “DHCP”.
A
Press
{T}
or
{U}
until the fol-
lowing message appears.
<System Menu>
j
37.Net Boot
l
B
Press
{
Enter
}
.
The current setting appears on
the panel display.
<Net Boot>
j
*None
l
C
Press
{U}
or
{T}
until the
method you want to use ap-
pears.
D
Press
{
Enter
}
.
H
If you use NetWare, select the
NetWare frame type.
Select one of the items below if
necessary.
• Auto Select (Default)
• Ethernet SNAP
• Ethernet 802.2
• Ethernet 2
• Ethernet SNAP
Note
❒
In most situations, use the de-
fault setting (“Auto Select”).
When you select “Auto Select”,
the frame type first detected by
the printer is adopted. If the net-
work can use more than two
frame types, the printer may fail
to select the correct frame type if
“Auto Select” is selected. In this
case, select the appropriate
frame type.
A
Press
{T}
or
{U}
until the fol-
lowing message appears.
<System Menu>
j
38.Frame NW
l
B
Press
{
Enter
}
.
The current setting appears on
the panel display.
<Frame NW>
j
*Auto Select
l
Menu item on the
panel display
Available methods
AR
*1
RA
*2
BO
*3
DH
*4
ARP+PING
'
ARP & RARP
' '
ARP & BOOTP
' '
ARP&RARP&BOOTP
' ' '
None
(Default Setting)
RARP+TFTP
'
BOOTP
'
RARP & BOOTP
' '
DHCP
'