Ricoh AFICIO AP306, Setup Manual

Page: 107 / 382

Draft 2000/06/22
21
3. Paper and Other Media
Paper and Other Media Supported by This
Printer
Paper Types and Sizes
This section describes the type, size, feed direction, and maximum amount of pa-
per that can be loaded into each paper tray in this printer.
Important
❒
If you use damp or curled paper, a misfeed might occur. In such a case, try
turning over the paper stack in the paper tray. If there is no improvement,
change to paper with less curl.
❒
Be sure to set the paper size dial to match the actual paper size loaded in the
tray. When the actual paper size is not shown on the dial, set the dial to “
p
”
and selected the paper size using the operation panel.
❒
For Tray 1, 2, and 3, the dial setting overrides settings selected with the oper-
ation panel.
Note
❒
The following conventions are used to describe paper feed direction:
❒
When loading paper having the same size in more than one tray, it is recom-
mended that you load paper in the same direction.
❒
The supported paper sizes may differ depending on the memory capacity of
the printer.
⇒
P.117 “Memory Capacity and Paper Size”
❒
For more information about the meanings of symbols, see the notes at the bot-
tom of each table.
Reference
For more information about loading each type of paper, see P.25 “Types of pa-
per and other media” .
Symbol in this manual Symbol on the panel
display
Meaning
K
mn
Short-edge feed direction
L
op
Long-edge feed direction