REXROTH RD 500 Series, Applications Manual

Page: 211 / 276

RD 500 RD51 Operator Control and Visualization
7-3
DOK-RD500*RD51*******-IB04-EN-P
Fast Parameterization using Key Combinations
Key Response
+
If these keys are simultaneously pressed:
– the complete parameter number is set to zero
(numerical list).
– the complete parameter value is set to zero (for numerical
parameters).
+
If these two keys are pressed simultaneously, the factory setting of the
active value is set.
Mon
+
Prog
If these keys are simultaneously pressed, the system changes from the
monitor or prog. area into a temporary actual value display.
When the ESC key is pressed again, the display goes back to the selected
menu. In order for the user to be able to differentiate between the standard
operating display and the temporary actual value display, the temporary
actual value display has a flashing frame.
Fig. 7-5: Key combinations
Load Standard Values
When the drive converter or inverter is supplied, the parameters are set to
standard values. The “Load factory setting” function can also be activated
by parameter P0071.
SET PARAMETERS
Prompted parameterization
Unit setting
P0071 Load factorySetting
No action
Basic parametrizat.
Free parametrizat.
NAMUR applications
Sercos applic. free
Note: All of the parameters of the selected password level are reset
using the “Load factory setting” function.
Depending on the application, the user must adapt the following
parameters after the standard values have been set.
Application /
output frequency Option Firmware Pulse
frequency
-200 Hz Without filter 4 kHz
-200 Hz With sinusoidal filter FWA-RD500*-02x-xxVRS-MS-RD52 8 kHz
-1000 Hz With / without sinusoidal filter FWA-RD500*-10x-xxVRS-MS-RD52 10 kHz
- 1400 Hz With / without sinusoidal filter FWA-RD500*-14x-xxVRS-MS-RD52 12 kHz
Fig. 7-6: P0026 pulse frequency