R&S FSW Series, User Manual

Page: 1067 / 1450

Remote Commands
R&S
®
FSW
1067 User Manual 1173.9411.02 ─ 43
Manual operation: See "Adjusting the Center Frequency Automatically (Auto Fre-
quency)" on page 498
[SENSe:]ADJust:LEVel
This command initiates a single (internal) measurement that evaluates and sets the
ideal reference level for the current input data and measurement settings. This ensures
that the settings of the RF attenuation and the reference level are optimally adjusted to
the signal level without overloading the R&S
FSW or limiting the dynamic range by an
S/N ratio that is too small.
Example: ADJ:LEV
Manual operation: See "Setting the Reference Level Automatically (Auto Level)"
on page 454
14.7.6 Configuring the Data Input and Output
The following commands are required to configure data input and output.
● RF Input .............................................................................................................. 1067
● Using External Mixers ......................................................................................... 1074
● Setting up Probes ................................................................................................1089
● External Generator Control ................................................................................. 1095
● Working with Power Sensors .............................................................................. 1107
● Configuring the Outputs .......................................................................................1118
14.7.6.1 RF Input
CALibration:PADJust[:STATe]
........................................................................................ 1067
INPut<ip>:ATTenuation:PROTection:RESet
.....................................................................1068
INPut<ip>:CONNector
.................................................................................................. 1068
INPut<ip>:COUPling
.....................................................................................................1069
INPut<ip>:DPATh
......................................................................................................... 1069
INPut<ip>:FILTer:HPASs[:STATe]
................................................................................... 1070
INPut<ip>:FILTer:YIG[:STATe]
........................................................................................1070
INPut<ip>:IMPedance
...................................................................................................1071
INPut<ip>:IMPedance:PTYPe
....................................................................................... 1071
INPut<ip>:SELect
........................................................................................................ 1072
INPut<ip>:TYPE
.......................................................................................................... 1073
INPut<ip>:UPORt:STATe
...............................................................................................1073
INPut<ip>:UPORt[:VALue]
............................................................................................ 1074
CALibration:PADJust[:STATe]
Activates or deactivates the preselector adjustment.
Setting Basic Measurement Parameters