Remote Commands
R&S
®
FSW
1073
User Manual 1173.9411.02 ─ 43
AIQ
Analog Baseband signal (only available with optional Analog
Baseband Interface R&S
FSW-B71)
For details on Analog Baseband input see the R&S
FSW I/Q
Analyzer User Manual.
Not available for Input2.
*RST:
RF
Example:
INP:TYPE INP1
For R&S
FSW85 models with two RF input connectors: selects
the 1.00
mm RF input connector for configuration.
INP:SEL RF
Manual operation:
See
INPut<ip>:TYPE
<Input>
The command selects the input path.
Suffix:
<ip>
.
1..n
Parameters:
<Input>
INPUT1
Selects RF input 1.
1
mm [RF Input] connector
INPUT2
Selects RF input 2.
For R&S
FSW85 models with two RF input connectors:
1.85
mm [RF2 Input] connector
For all other models: not available
*RST:
INPUT1
Example:
//Select input path
INP:TYPE INPUT1
Manual operation:
See
INPut<ip>:UPORt:STATe
<State>
This command toggles the control lines of the user ports for the
AUX PORT
connector.
This 9-pole SUB-D male connector is located on the rear panel of the R&S
FSW.
See the R&S
FSW Getting Started manual for details.
Setting Basic Measurement Parameters
