R&S FSW Series, User Manual

Page: 371 / 1450

Common Measurement Settings
R&S
®
FSW
371 User Manual 1173.9411.02 ─ 43
Remote command:
INPut<ip>:CONNector
on page 1068
8.2.2.2 Probe Settings
Access : [INPUT / OUTPUT] > "Input Source Config" > "Probes"
Data input for the measurement can be provided by probes if the optional Analog
Baseband Interface (R&S
FSW-B71) is available or the R&S RT-ZA9 adapter is used.
For each possible probe connector (Baseband Input I, Baseband Input Q, RF), the
detected type of probe, if any, is displayed.
For more information on using probes with an R&S FSW, see Chapter 8.2.1.1, "Using
Probes" , on page 358.
For general information on the R&S
®
RT probes, see the device manuals.
Name ...........................................................................................................................371
Serial Number ............................................................................................................. 372
Part Number ................................................................................................................372
Type ............................................................................................................................ 372
Mode ........................................................................................................................... 372
Common Mode Offset / Diff. Mode Offset / P Offset / N Offset / ................................ 372
Attenuation .................................................................................................................. 372
Microbutton Action ...................................................................................................... 373
Name
Probe name
Remote command:
[SENSe:]PROBe<pb>:SETup:NAME?
on page 1092
Data Input and Output