VTrak M610p Product Manual
218
Figure 4. Fan LED
Under normal conditions, the power supply and fan LEDs should display green.
To check a component’s installation, follow the same procedure as replacing the
component, except that you reinstall the original component rather than a new
one. In most cases, this action fixes a bad connection and allows VTrak to detect
the component. If this action does not correct the problem, replace the unit. See
page 175 for instructions.
The Controller Location LEDs, on the back of the VTrak subsystem, will flash for
one minute.
Figure 5. The VTrak M610p controller LEDs
Under normal conditions, the Controller Status LED (marked with
icon) is
green and the Dirty Cache LED (marked with
) icon is dark. See the table
below.
LEDs
State
Dark
Green
Amber
Red
Power supply
Not detected
OK
Fan failed
Failed
Fan
Not detected
OK
Wrong speed
Failed
Fan LED
Mgmt
CONSOLE
Status LED
Dirty Cache LED
Summary of Contents for VTRAK M610p
