71
5
86
81
2
2a
2.1
Assembly of Rail Connector
LPS
The Climbing Rail LPS (2) and (2a) are
extended by means of the Rail Connec-
tor LPS (5).
1. Remove or re-position Spacers (2.1) in
the Climbing Rail that are in the way.
2. Insert Rail Connector LPS (5) into the
Climbing Rail LPS (2). The mounting
direction of the Rail Connector is car-
ried out as shown.
3. Secure Rail Connector by inserting 2x
Fitting Pins Ø 21x120 (81) and Cotter
Pins 4/1 (86) through holes Ø 21.
4. Position additional Climbing Rail (2a)
on Rail Connector SRU/LPS, and se-
cure by inserting 2x Fitting Pins Ø
21x120 and Cotter Pins 4/1 through
holes Ø 21.
(Fig. C1.07 + C1.08)
– When mounting Climbing Rails that
are longer than those specified in the
standard configuration, the static
load-bearing capacity of the Rail Con-
nector for wind loads and load case
erection must be verified.
– Screen Adapters cannot be mounted
in the area of the Rail Connector.
Note
When Fitting Pins (81) are mounted on
the inside of the Climbing Rail, the Fit-
ting Pins collide with the guiding skids of
the Rail Guidance Shoe.
This can cause damage to the climbing
enclosure and reduce the load-bearing
capacity of the anchoring.
⇒
⇒
Always install the Climbing Rail Con-
nector and Fitting Pins on the outside.
Components
2
Climbing Rail-2 LPS
2.1
Spacer LPS 52
5
Rail Connector LPS
81
Fitting Pin Ø 21x120
86
Cotter Pin 4/1
C1 Pre-Assembly
Fig. C1.07
Fig. C1.08
LPS Screen Lightweight Climbing Enclosure
Instructions for Assembly and Use – Standard Configuration