![background image](http://html.mh-extra.com/html/omron/zw-c1-t/zw-c1-t_user-manual_1633390267.webp)
Connecting Parallel I/O
ZW User's Manual
265
Senso
r con
trol
ler ope
ra
ti
ons
9
Assigning Analog Output
As an example, here is an explanation of the procedure for outputting the results of TASK1 as analog.
Operating procedure
Setting Monitor Focus
The following describes the procedure when setting 4 mA output (Point1) for measured value of 0 mm and 20
mA output for measured value of 6mm (Point2).
Operating procedure
Steps
Key operation
Display
Description
1 to 3
For moving to "ANALOG", see steps 1 to 3 in p.264.
2
Press the
/
keys to select "OUTPUT" and press the
key.
3
Select the task to output.
TASK1 to TASK4/OFF
The current setting value is displayed on the sub-display.
Press
/
key to enter editing mode and the sub-display blinks.
In this example, select "TASK1" and press the
key.
4
Press the
key for two seconds to enter the RUN mode.
Steps
Key operation
Display
Description
1 to 3
For moving to "ANALOG", see steps 1 to 3 in p.264.
4
Press the
/
keys to select "FOCUS" and press the
key.
Summary of Contents for ZW-C1*T
