NEW BRUNSWICK SCIENTIFIC BioFlo 415, Manual To Operations

Page: 28 / 164

16
BioFlo 415
y
M1360-0050 User’s Guide
Figure 4: Sparge Assembly
ƒ
Exhaust Assembly
This assembly (
see Figure 5 on the following page
) consists of an exhaust
condenser; exhaust heater, exhaust filter, and condensate return line. The
entire assembly can be inserted into any 12mm port on the vessel headplate;
see Figures 3a & 3b for the recommended location
.
1. After the exhaust and sample lines are attached to the vessel, reattach the
parts of those lines that were removed prior to assembly.
2. Make sure the sample septum/tri-clamp cap is in place on the
harvest/sample tube assembly.
3. Make sure the exhaust condenser’s heater pad is plugged in (
see Figure
1a
).
INLET FILTER:
install filter into
SIP housing
CONDENSATE RETURN:
connect cable to FY2A on side
of cabinet
SPARGE VALVE:
Be sure to read WARNING in
Section 8.2.3.
Pull & hold the ring out. Lift
the sparger tube up to put
sparger into sterilization
position, or push tube down
to put the sparger into sparge
position. Release the valve
ring.
To “FILTER
Ý
CONDENSATE” on side of the cabinet
. ...
To “SPARGE”
Û
on the side of the cabinet .. ...
SPARGE TUBE