NEW BRUNSWICK SCIENTIFIC BioFlo 415, Manual To Operations

Page: 29 / 164

17
New Brunswick Scientific User’s Guide
Figure 5: Exhaust Condenser Assembly
4.6.2 Other Ports & Plugs
1. If you have this option, insert the 19mm septum/charging port into the
septum port (
see Figures 3a & 3b
).
2. Insert the vessel light into the proper port (
see Figures 3a & 3b
).
3. Insert any remaining plugs/ports into the headplate before beginning the
next step.
4.6.3 Insert Probes
Dissolved oxygen and pH probes are installed directly into the vessel
headplate. Additional probes may be installed using the 19mm port and an
adapter fitting, as described below. To install a probe in the 19mm port:
1.
Apply a small amount of vacuum grease to the external threads of the
adapter plug, then insert the plug into the available 19mm port on the
headplate.
See Figures 3a & 3b for recommended locations.
2. Tighten the plug until it bottoms out in the port.
3. Insert the probe into the adapter plug until the threads on the probe engage
into the top of the plug
4. Tighten the probe into the adapter until the probe is firmly attached.
EXHAUST FILTER:
install filter into
SIP housing
CONDENSATE RETURN:
connect cable to FY3B
(on side of Control Cabinet)
Û
From lower vessel jacket water inlet:
Brings water into condenser (see
Figure 7.)
Þ
To “FILTER CONDENSATE”
(on side of Control Cabinet)
×
To “VESSEL EXHAUST”
(on side of Control Cabinet)
To “UPPER CONDENSER”
(on side of Control Cabinet)
EXHAUST HEATER WIRE