MUTOH Zephyr TS, User Manual, Page: 203 / 300

User’s Guide Zephyr TS
User preferences
AP-75390 - Revision 1.0 203
5
Heater settings
In this window, you have the opportunity to set the intelligent heater control or set the heaters
manually. It is recommended to use the intelligent heater control. This way, the heaters are
automatically adjusted to the needed temperature. When using manual heater control, you
can set the temperature you want. Change the heater settings with the slide bar in the manual
heater control window.
Next to this, you can select whether to wait printing until the heaters have reached their
temperature of not.
You can also set the time the heaters have to remain active after the print job.
A: max. 50°C
B: max. 50°C
C: max. 50°C
C
Heater element Temperature function
Pre-heater (A) Max: 50
Conditions the media to avoid sudden
temperature shocks to avoid curling
Fixer (B) Max: 50
Control the temperature and to make sure
there's a smooth transition in temperature to
avoid curling. This has also influence on
the dot gain.
Post fixer (C) Max: 50
Controls the temperature and to make sure
there's a smooth transition in temperature to
avoid media cockling.
Note

Be aware, when working with the intelligent heater control mode, all RIP
parameters concerning the heaters will be ignored.