MUTOH Zephyr TS, User Manual, Page: 110 / 300

User’s Guide Zephyr TS
Basics
110 AP-75390 - Revision 1.0

In case the arrow heads are no where in the complete pattern pointing correctly
to each other as in the example above, look how the arrows are pointing.

If the left arrow is lying higher then the right arrow head. reprint the step
adjust pattern with a correction of +0.2%.

If the right arrow is lying higher then the left arrow head, reprint the step adjust
pattern with a correction of - 0.2%.
Step 8:
Once you have found the position where the arrow heads touch each other
correctly, check the colour density of the print pattern.

In case the density of each half circle is equal, use the value next to the pattern.

In case the density of each half circle is not equal, fine tune the step adjust
pattern. To do so, look for the turning point where the dark side switches side.

Reprint the step adjust pattern with a correction value for example 0.12%
+0.15 %
+0.15 %
+0.1 %
Note

Be aware that the value next to each pattern is a relative value. This means you
have to increase or decrease the current value with the value next to the
pattern.

For example, the current step is set to 0.15 and the step adjust pattern gives
you a perfect pattern at -0.05%. This means you have to set your step to 0.15 -
0.05 = 0.1.