MUTOH Zephyr TS, User Manual, Page: 14 / 300

User’s Guide Zephyr TS
Safety instructions
14 AP-75390 - Revision 1.0
Handling ink:

Only use original manufacturer's ink and appropriate cleaning liquid. Before filling the ink,
shake it gently. Doing so will preserve print quality.

When ink is moved from a cold place to warm place, keep the ink for three hours or more
in the new printing environment before printing.

When refilling ink, use original manufacturer's ink. This printer is designed to use original
ink. If you use inks which are not produced by the original manufacturer:

printing might become blurred

curing (speeds) might be a problem

any problems caused by using ink other than those recommended above will not be
covered by the warranty, and repair expenses will have to be paid by the customer.

For handling waste: see section 13 on the MSDS-sheet. Recommendation: dispose of
product according to federal, state, provincial and local regulations.

Do not store ink/waste in direct sunlight to prevent the ink from curing.

Waste tank has to be opaque, preferably black.

Never fill the waste tank completely because of possible swelling due to curing. Leave 4
cm open on top.

Inks / Waste

General advice : wear safety glasses and gloves

After spill: remove contaminated clothing.

After inhalation: if difficulties occur after vapour/aerosol has been inhaled, remove to
fresh air and seek medical attention.

After skin contact: wash thoroughly with soap and water.

After eye contact: wash affected eyes for at least 15 minutes under running water
while eyelids held open.

After swallowing: rinse mouth and drink plenty of water. Never induce vomiting. Seek
medical attention.