Molecular Devices FLIPR Tetra, User Manual

Page: 268 / 302

Robotic Integration
268 0112-0109 H
The table below documents the errors one might encounter when
sending the runexperiment command. The errors explain how the
currently opened protocol doesn’t match instrument configure or
instrument is not ready to run current protocol.
C62 The pump speed can only be Slow or Fast.
C63 Invalid number of wash strokes.
C64 Invalid number of parameters for the wash tips command.
C65 Invalid number of wash cycles.
C66 Invalid protocol parameters discovered at runtime.
C67 Invalid wash fluid parameter.
C68 Can't wash tips, tips are not on.
C69 Unrecognized or badly formatted command.
C70 Volume stroke too large.
C71 Volume stroke too small.
C72 Hold time is too small.
C73 Hold time is too large.
C74 Dispense speed is too large.
C75 Dispense speed is too small.
C76 Cell flask stirring rate parameter was not sent.
C77 Parameter is out of range.
C78 The number of parameters for wash Cell Reservoir commands is
invalid.
C79 Invalid volume parameter. It must be 'low' or 'high'.
Table A-4 runexperiment command errors
Error
Code
Description
E100 Invalid LED filter combination! Calibrate it or choose valid
combination.
E110 Plate does not exist in plate library. Choose existing plate or add
it into plate library.
E111 Plate is not present or is not in the proper location.
Table A-3 Error Types interface errors (cont’d)
Error
Code
Description