Mitsubishi MELSEC-Q QD77MS, User Manual

Page: 828 / 976

15- 15
Chapter 15 Dedicated Instructions
15.6 ZP.PINIT
This dedicated instruction is used to initialize the setting data of the QD77MS.
Usable device
Internal device Link direct device J \ Constant
Setting
data
Bit Word
File
register
Bit Word
Intelligent
function
module
U \G
Index
register
Zn
K, H
Others
(S) – – – –
(D) – – – –
[Instruction symbol] [Execution condition]
ZP.PINIT
ZP.PINIT "Un" (S) (D)
[Setting data]
Setting data Setting details
Setting side
(Note-1)
Data type
"Un"
QD77MS head I/O number
(00 to FE: High-order two digits of I/O number expressed in three digits)
User BIN 16 bits
(S) Head number of a device in which control data is stored – Device name
(D)
Head number of a bit device which turns ON the operation by one scan at the
time of completion of the instruction.
If the instruction is completed abnormally, ((D) + 1) will also be turned ON.
System Bit
Note) The file register of each of the local device and the program cannot be used as a device for setting data.
(Note-1): The data on the setting side is as follows.
• User : Data before the execution of dedicated instructions is stored by user.
• System: Data after the execution of dedicated instruction is stored by PLC CPU.
[Control data]
Device Item Setting data Setting range
Setting side
(Note-1)
(S)+0 System area – – –
(S)+1 Complete status
The state at the time of completion is stored.
0 : Normal completion
Other than 0: Abnormal completion (error code)
(Note-2)
– System
(Note-1): The data on the setting side is as follows.
• User : Data before the execution of dedicated instructions is stored by user.
• System: Data after the execution of dedicated instruction is stored by PLC CPU.
(Note-2): Refer to Section 16.5 for error codes at abnormal completion.