Mazda 6 2002, Workshop Manual

Page: 405 / 1248

J–8
MANUAL TRANSAXLE
Manual Transaxle Installation Note
1. Set the transaxle on a jack and lift into place.
2. Install the transaxle mounting bolts.
3. Tighten the
SST (49 E017 5A0)so that the engine
is located at the specified position.
No.1 Engine Mount and No.4 Engine Mount Bracket Installation Note
1. Verify that the engine mount rubbers are installed as shown.
2. By aligning the holes with the stud bolts, install the No.4 engine mount bracket to the transaxle.
3. By aligning the holes with the stud bolts, install the No.1 engine mount to the transaxle.
4. Align the hole of the No.4 engine mount bracket with the No.4 engine mount rubber on vehicle, and temporarily
tighten the bolt D.
5. Tighten the nut B,C in order of B
→
C, then bolt A.
6. Tighten the bolt D.
7.
Tightening torque
A, B, C: 66.6—93.1 N·m {6.8—9.4 kgf·m, 50—
68 ft·lbf}
D: 85.3—116.6 N·m {8.7—11.8 kgf·m, 63—85
ft·lbf}
8. Tighten the bolt D to the No.1 engine mount.
Tightening torque
E: 85.3—116.6 N·m {8.7—11.8 kgf·m, 63—85
ft·lbf}
9. Remove the SST (49 E017 5A0).
End Of Sie
A6E5112W004
A6E5112W005
A6E5112W006