Mazda 6 2002, Workshop Manual

Page: 430 / 1248

AUTOMATIC TRANSAXLE
K–23
K
Off-vehicle inspection
1. Remove the oil pressure switch.
2. Apply air pressure at 400—440 kPa {4.1—4.4kgf/cm
2
,58—63psi}
3. Inspect continuity the between oil pressure switch
terminal and screw part.
•
If not as continuity, replace the oil pressure
switch. (See
K–23 OIL PRESSURE SWITCH
REMOVAL/INSTALLATION .)
4. Install the oil pressure switch.
End Of Sie
OIL PRESSURE SWITCH REMOVAL/INSTALLATION
A6E561421550W02
Warning
•
When the transaxle and ATF are hot, they can badly burn. Turn off the engine and wait untill they
are cool before replacing ATF.
1. Disconnect the negative battery cable.
2. Remove the under cover.
3. Disconnect the cord assembly connector.
4. Remove the oil pressure switch.
5. Install the oil pressure switch.
Tightening torque
17.1—22.1N·m {1.75—2.25kgf·m, 13—
16ft·lbf}
6. Connect the oil pressure switch connector.
7. Install the under cover.
8. Connect the negative battery cable.
End Of Sie
INPUT/TURBINE SPEED SENSOR INSPECTION
A6E561421550W03
Caution
•
Water or foreign objects entering the connector can cause a poor connection or corrosion. Be
sure not to drop water or foreign objects on the connector when disconnecting it.
1. Disconnect the negative battery cable.
2. Remove the battery and battery tray.
3. Remove the air cleaner component. (See
F–10 INTAKE-AIR SYSTEM REMOVAL/INSTALLATION .)
4. Disconnect the input/turbine speed sensor
connector.
A6E5614W028
A6E5614W026
A6E5614W030