Mazda 6 2002, Workshop Manual

Page: 443 / 1248

K–36
AUTOMATIC TRANSAXLE
2. Install the control valve body component.
Tightening torque
7.8—10.8 N·m
{80—110 kgf·cm, 70—95 in·lbf}
Bolt length (measured from below the head)
B: 40 mm {1.575 in}
No mark: 70 mm {2.756 in}
3. Install the oil strainer.
4. Match the harness colors, then connect the
solenoid connector and TFT sensor connector.
5. Install the ground.
Tightening torque
7.8—10.8 N·m {80—110 kgf·cm, 70—95
in·lbf}
6. Apply a light coat of silicon sealant to the contact
surfaces of the oil pan and transaxle case.
7. Install the oil pan.
Tightening torque
6—8 N·m {62—81 kgf·cm, 53—70 in·lbf}
8. Install the crossmember. (See R–23 FRONT
CROSSMEMBER REMOVAL/INSTALLATION .)
9. Install the front tires and splash shield.
10. Install the under cover.
11. Connect the negative battery cable.
12. Add ATF and with the engine idling, inspect the
ATF level. (See K–13 AUTOMATIC TRANSAXLE
FLUID (ATF) REPLACEMENT .)
13. Carry out the mechanical system test. (See K–6 MECHANICAL SYSTEM TEST .)
14. Carry out the road test. (See K–9 ROAD TEST .)
End Of Sie
OIL COOLER FLUSHING
A6E561419900W01
Note
•
The contaminated cooler line (oil pipes and hoses) and auxiliary cooler must be flushed completely when
ATX is overhauled or replaced.
Spring
Color of connector
(harness side)
Pressure control solenoid Black
Shift solenoid A White
Shift solenoid B Blue
Shift solenoid C Green
Shift solenoid D white
Shift solenoid E Black
A6E5614W062
A6E5614W063
A6E5614W064