Mazda 6 2002, Workshop Manual

Page: 786 / 1248

POWER WINDOW SYSTEM
S–29
S
7. Remove the power window regulator from the
speaker installation hole.
8. Install in the reverse order of removal.
End Of Sie
POWER WINDOW MOTOR REMOVAL/INSTALLATION
A6E771659560W01
1. Disconnect the negative battery cable.
2. Remove the front door trim or rear door trim.
3. Disconnect the power window motor connector.
4. Remove the bolts.
5. Remove the power window motor from the power
window regulator drum.
6. Install in the reverse order of removal.
Note
•
When installing the power window motor to
the power window regulator drum, the drum
housing hook may come off the door unit. If
this happens, remove the door speaker,
insert your hand in the speaker installation
hole, connect the drum housing hooks, and
while supporting the drum housing, install
the power window motor to the drum.
End Of Sie
POWER WINDOW MOTOR INSPECTION
A6E771659560W02
Driver’s Side
1. Disconnect the power window motor connector.
2. Apply battery positive voltage to the power
window motor terminals E and F and inspect the
operation the power window motor operation.
•
If not as specified, replace the power window
motor.
3. Apply battery positive voltage to the power
window motor terminal D and connect terminal C
to ground.
4. Measure the voltage at terminal B and A while performing Step 3.
•
If not as specified, replace the power window motor.
Voltage
Pulse wave: MAX. 5 V, MIN. 0 V
A6E7716W007
A6E7716W004
Motor operation
Terminal
F E
UP GND B+
DOWN B+ GND
A6E7716W008