Mazda 6 2002, Workshop Manual

Page: 961 / 1248

T–66
WIPER AND WASHER
INTERMITTENT REAR WIPER RELAY REMOVAL/INSTALLATION
A6E811666810W01
5HB
1. Disconnect the negative battery cable.
2. Remove the trunk side trim. (See
S–92 TRUNK SIDE TRIM REMOVAL/INSTALLATION )
3. Remove in the order indicated in the table.
4. Install in the reverse order of removal.
End Of Sie
INTERMITTENT REAR WIPER RELAY INSPECTION
A6E811666810W02
1. Connect the connector to the intermittent rear wiper relay.
2. Connect the negative battery cable.
3. Measure the voltage at the intermittent rear wiper relay using voltmeter.
•
When inspecting terminal D for continuity, disconnect the intermittent rear wiper relay connector.
4. If the value are not as specified in the Terminal Voltage List (Reference), inspect the parts under “Action” and
related wiring harnesses.
5. If the system does not work properly even though the parts or related wiring harnesses do not have any
malfunction, replace the intermittent rear wiper relay.
Terminal Voltage Table (Reference)
1 Connector
2 Bolt
3 Interittent rear wiper relay
A6E8116W101
Terminal Signal Connected to Test condition
Voltage (V)/
Continuity
Action
A Autostop Rear wiper motor
Rear wiper is operating (INT
position or ON position) Alternates 0
and B+
•
Inspect R. WIP 10 A
fuse
•
Inspect wiper and
washer switch (See
T–
68 WIPER AND
WASHER SWITCH
INSPECTION
)
•
Inspect rear wiper
motor (See
T–62
REAR WIPER MOTOR
INSPECTION
)
•
Inspect related harness
Other B+
D GND GND
Under any condition: inspect for
continuity to ground
Yes
•
Inspect GND
•
Inspect related harness
A6E8116W134