Mazda 6 2002, Workshop Manual

Page: 459 / 1248

AUTOMATIC TRANSAXLE SHIFT MECHANISM
K–49
K
Caution
•
Bending the selector cable in the manner
shown in the figure will damage the cable
and it may become loose when shifted.
When installing the selector cable, hold it
straight.
Note
•
Install the selector lever to the manual shaft
lever with the spring side of the selector
cable end facing the front of the vehicle.
6. Install the selector lever to the manual shaft lever
so that no load acts on the selector cable.
7. Confirm that the tip of the manual shift lever projects out of the end of the selector cable.
8. Install the selector cable to the selector cable securely bracket.
Interlock Cable Installation Note
1. Install the interlock cable as shown in the figure.
Caution
•
Position the sponge protector so that it is
not crushed or squeezed by the SAS unit.
•
If the interlock and selector cables cross
over each other, position the interlock
cable to pass over the selector cable.
2. Push the snap pin (or a
φ
1.5 round bar or
simular.) into hole A by fully pushing the slider pin
in.
3. Push the snap pin into hole B and hole C of the
lock unit until it passes through.
4. Disconnect the brake switch connector.
5. Remove the brake switch. (See
P–9 BRAKE
PEDAL REMOVAL/INSTALLATION .)
6. Install the new brake switch. (See P–9 BRAKE
PEDAL REMOVAL/INSTALLATION .)
Caution
•
Do not connect the brake switch
connector until the interlock cable is
installed.
7. With the slider pin pressed, slide the lock unit to
fix the lock unit hook into the bracket hole
securely as shown in the figure.
Caution
•
Allowing the interlock cable to be bent or
twisted during installation can affect the
lock unit operation.
8. Rotate the slider pin to release the lock, and verify
that the it slides freely.
A6E5616W008
SAS UNIT WIRING HARNESS
SAS UNIT
SELECTOR
CABLE
INTERLOCK
CABLE
SPONGE PROTECTOR
A6E5616L001
SLIDER PIN
INTERLOCK
CABLE
BRAKE SWITCH
A
B
C
LOCK UNIT
CHU0514W012
SLIDER PIN
LOCK UNIT
BRACKET
BHE0514W007